상세 보기
순간접착제 침지 코팅이 재료 압출 방식으로 제작된 PLA 구조물의 기계적 특성에 미치는 영향
- 김성준;
- 배승리;
- 박성제
초록
Material extrusion (MEX) is widely used in additive manufacturing due to its simplicity and compatibility with various thermoplastics. While adhesive coating is commonly applied to enhance the watertightness of MEX-fabricated (MEXed) structures, its impact on mechanical properties remains unclear. This study investigated the effect of cyanoacrylate adhesive dip coating on the mechanical behavior of MEXed polylactic acid (PLA) specimens. Tensile specimens were fabricated in both longitudinal and transverse orientations and coated with two commercial cyanoacrylate adhesives, Loctite 401 and Alaska 4001. The coating process was repeated 2, 4, and 6 times, followed by cross-sectional observations and tensile testing. The results indicated that the cross-sectional area increased with an increasing number of coating repetitions, regardless of adhesive type or infill pattern. Tensile strength generally decreased after coating, with reductions of 10.6–14.7% after six coating cycles. In contrast, the elongation at break increased after coating treatment. For Loctite 401, the maximum increases were approximately 35.1% and 124.1% for the longitudinal and transverse specimens, respectively, while Alaska 4001 resulted in maximum increases of approximately 29.7% and 48.3%, respectively. These findings suggest that adhesive dip coating significantly alters the mechanical behavior of MEXed PLA structures and requires optimization to balance strength and ductility.
키워드
- 제목
- 순간접착제 침지 코팅이 재료 압출 방식으로 제작된 PLA 구조물의 기계적 특성에 미치는 영향
- 제목 (타언어)
- Influence of Cyanoacrylate Adhesive Dip Coating on the Mechanical Properties of Material Extrusion-fabricated PLA Structures
- 저자
- 김성준; 배승리; 박성제
- 발행일
- 2026-10
- 유형
- Y
- 저널명
- 한국정밀공학회지
- 권
- 43
- 호
- 10
- 페이지
- 1129 ~ 1136
- 언어
- ENG
- 출판사
- 한국정밀공학회
- 발행국가
- 대한민국
- 분량
- 8 페이지
- ISSN
- E 2287-8769
P 1225-9071