Bimodal structured chromium-tungsten composite as plasma-facing materials: Sinterability, mechanical properties, and deuterium retention assessment

Abstract

Even though tungsten (W) is considered to be the most favored plasma-facing material (PFM) for nuclear fusion reactors thanks to its beneficial physical properties, its advantage for those plasma-facing components to be subjected to medium heat flux and high neutron irradiation dose is compromised by unfavorable nuclear behavior such as intermediate-level radioactive waste activation and embrittlement caused by lattice damage and transmutation. Chromium (Cr) or Cr-based materials may have the potential to mitigate these shortcomings while maintaining acceptable thermal and physical performances required for PFM. They could offer attractive design options, particularly for those parts where the particle fluxes are relatively low and the heat flux is not too high (≤ 5 MW/m²) while nuclear loads are high (≥ 5 dpa). In this article, we report the first results of a preliminary technology feasibility study for an engineered Cr-based material fabricated based on a powder-metallurgical route. To explore an optimal metallurgical condition ensuring reasonable mechanical properties and low deuterium retention, a novel two-phase Cr-W composite was developed via current-assisted rapid sintering at low sintering temperature. The composite showed a cell-like bimodal microstructure consisting of a coarse-grained Cr phase surrounded by a 3D interconnected network of an ultrafine-grained W phase. The composite exhibited substantial improvements in ductility as well as high-temperature strength compared to pure W and Cr. After undergoing W heavy ion irradiation, the damaged Cr-W composite with a two-phase bimodal microstructure showed a comparable deuterium retention capacity to pure W. Finally, the potential applicability as PFM is discussed. © 2023 Acta Materialia Inc.